Curve jig in place. Pieces are loose, until placed up against curve, then stapled to crossmember.
Viewed: 1393 times.
|
Place the tips of the jig on surface to be cut. Then mark a dot at each point. Remove jig. Drive a nail at each mark. Use a batten against the nails to draw the curve. Voila, an (almost) exact copy of the curve you were duplicating.
Viewed: 1353 times.
|
How do you bend the transom to fit if there's only one of you? Cargo straps and a 4x4.
Viewed: 1722 times.
|
Transom bending detail 2
Viewed: 1623 times.
|
Transom bending detail 3
Viewed: 1273 times.
|
Lazarette/Transom bending jigs detail 1
Viewed: 1110 times.
|
Lazarette/transom bending jig detail 2
Viewed: 1364 times.
|
Routing the portlights with a template and flush trim bit.
Viewed: 1541 times.
|
Barry Pyeatt from the byyb.org forums used a 4x4 in a simpler method of the cargo straps that I used.
Viewed: 1434 times.
|
